Application	N•m	Lb-Ft	Lb-In
B-Pillar Molding Screws	1.3	-	12
Mud Guard Bolts	2	-	18

---

1. Remove the outside channel molding. Refer to Section 9P, Doors.
2. Reposition the weatherstrip in order to access the screws.
3. Remove the screws and the B-pillar molding (front door B-pillar molding shown, rear door C-pillar molding similar).

---

Notice : Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the screws and the B-pillar molding (front door B-pillar molding shown, rear door C-pillar molding similar).
Tighten
Tighten the B-pillar molding screws to 1.3 N•m 12 (lb-in).


2. Install the weatherstrip to its original position.
3. Install the outside channel molding. Refer to Section 9P, Doors.

---

1. Remove the roof molding from the metal clips.

---

1. Press the roof molding onto the metal clips.

---

1. Remove the screw and the bolts and the mud guard.

---

Notice : Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the mud guard with the bolts and the screw.
Tighten
Tighten the mud guard bolts to 2 N•m (18 lb-in).

---

1. Open the tailgate.
2. Remove the Hatchback Door upper Garnish molding.
3. Remove the rear spoiler from the tailgate.

---

1. Install the rear spoiler on the tailgate with the nuts.