SECTION 9C
HORN(S)
Caution : Disconnect the negative battery cable before removing or installing any electrical unit or when a tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise noted.
SPECIFICATIONS
Fastener Tightening Specifications
Application
|
N•m
|
Lb-Ft
|
Lb-In
|
|
Horn Bolt
|
20
|
15
|
-
|
SCHEMATIC AND ROUTING DIAGRAMS
Horn(s) Wiring System
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
Horn(s)
Removal Procedure
- Disconnect the negative battery cable.
- Disconnect the electrical connector.
- Remove the bolt and the horn(s). (Left horn shown, right horn similar, if equipped.)
Installation Procedure
Notice : Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
- Install the horn with the bolt.
Tighten
Tighten the horn(s) bolt to 20 N•m (15 lb-ft). (Left horn shown, right horn similar, if equipped.)
- Connect the electrical connector.
- Connect the negative battery cable.
GENERAL DESCRIPTION AND SYSTEM OPERATION
Horn(s)
The horns are located under the hood. They are attached near the radiator at the front of the vehicle. The horns are actuated by pressing the steering wheel pad, which grounds the horns' electrical circuit.
