SEALING, CAULKING AND DEADNER
SEALING & CAULKING
Note : Seal the following areas to prevent air leaks water leaks, and rust.
ENGINE ROOM
DASH
FLOOR & TRUNK ROOM
REAR LAMP & TRUNK ROOM
ROOF
ROOF
SUN ROOF
HOOD & TRUNK LID
TAILGATE
FRONT & REAR DOOR
DEADNER
GENERAL DESCRIPTION
Deadner is properly designed and applied for reduce the vibration and noise. Also, it plays in maintaining the structural rigidity of the panel.
REPAIR PROCEDURE
-
- Remove the related parts.
- Seats, carpet.
- Trims, others.
-
- Removal of the damaged deadner.
- Peel off the damaged deadner with a steel spatula,
carefully.
-
- Clean and dry.
- Before applying the deadner, thoroughly clean and
dry the areas to be applied.
-
- Prelocation the new deadner on the panels to be
applied.
-
Note : Avoid the parts mounting holes and service
holes.
-
- Adhension of deadner.
- Heat the surface of deadner with a torch or heating gun until it adheres itself.
- Push and adhere to the panel with a rubber
spatula.
-
Note : In order to take full advantage of the deadner,
its face must adhere and contact the panels perfectly.
-
Caution : Be careful not to burn the composite parts
when beating.
- Install the related parts.
- Install in the reverse order in which they were removed.
